Low pressure can obtain high temperature, high heat but no pollution, oil thermal oil boiler is a full of vitality of the boiler. Because it has the advantages of simple operation, safety and environmental protection, high efficiency and high temperature control precision, it has a wide range of applications in modern industrial production. The thermic fluid heater cost is increasing with the popularity of thermal oil stoves. There are more and more manufacturers of heat conduction oil furnaces, and there will be large differences in the quotation of each heat conduction oil furnace. Zozen Boilers said buying a boiler is about the price, but more about the configuration and quality. Because the configuration of the oil heat conduction oil furnace is very complex, including the boiler body, burner, chimney, all kinds of valves, etc., these accessories products will also be caused by different manufacturers, different processes and different prices.
This series of thermal oil boilers use heat conduction oil as heat medium for heat transfer. Using the high temperature characteristic of heat conduction oil, heat conduction oil boiler can realize low pressure and high temperature heating. ZOZEN thermal oil boiler adopts unique process technology, high efficiency and energy saving, short oil boiling time; At the same time, tailor-made flue gas waste heat recovery system can maximize the utilization of heat energy. Heat conducting oil boiler to degassing dehydration operation, should be carried out in the cold state of the boiler start, and when the expansion tank medium temperature reaches 110-120 degrees Celsius, to carry out the two operations, so as to ensure good operation effect, and achieve the desired purpose.
The thermic fluid heater cost is reasonable. Cyclone separator is composed of cylinder body, lead-in pipe, top cap, overflow ring, guide vane and bottom plate, etc. Cyclone separator is a kind of water separation equipment with good separation effect. Its working principle and working process is: the higher velocity of the soda mixture, the introduction of tangential into the cylinder and rotating motion, under the action of centrifugal force, the water drops thrown to the wall of the cylinder, so that the soda initial separation. The separated water flows into the volume of drum water through the guide vane around the bottom of the cylinder. On saturated steam in the cylinder body to flow into the hat of the twists and turns in the corrugated plate clearance flow, under the action of centrifugal force and inertia force, water droplets fall to the corrugated plate, under the effect of adhesion formation water film dirty, through the wall into the steam drum water capacity, make further separation of soda, steam and saturated steam drum steam space is introduced from the hat around or above.
This series of boiler heating surface is sufficient, with advanced combustion device, can achieve NOx emission less than 30mg/m3, environmental protection effect is remarkable. At the same time, in order to better improve the utilization of heat energy, our company also for the boiler flue end of the configuration of energy saving device, air preheater or waste heat boiler and other energy saving equipment, the thermal efficiency can reach more than 95%. The high temperature flame generated after the burner ignition of this series of boiler products enters the inner coil tube to form a radiant heating surface, and rotates 180° forward through the back of the inner coil tube to enter the sandwich area of the inner and outer tubes to form a convective heating surface. Then the upper part of the interlayer enters the interlayer area of the middle and outer coil pipe, and the atmosphere is discharged into the chimney at the back of the interlayer area.
Oil fired thermic fluid heater are widely used in petrochemical, textile, printing and dyeing, plastics, rubber, food processing, wood processing, asphalt heating, carton production, vegetable dehydration, paint baking, sand mold drying casting, etc. Its heating temperature can reach 340℃ in liquid phase or 400℃ in vapor phase. Thermic fluid heater cost are reasonable and usually require uniform and stable heating. And does not allow the flame direct heating process heating temperature between 150℃-380℃ in a variety of production occasions can be used organic heat carrier heating.